nabocorp softwares

Hello,

cam2 pc is such a usefull piece of software and even now, since it can deal with RAW files with the newest version.

Unfortunately I cannot use this version. After upgrading in Tools/Options/Transfer I cannot switch to Canon Camera in Camera Type.
Each time I try, I am forced to the nabocorp website and asked to download the canon-files. But no matter how often I download them and install them, I am being asked to download them and the dropdown switches back to USB-Autoconnect.

After downgrading to 4.3.6 this works. But not with 4.4. I even tried the shareware version. Same problem.

I use WinXP Sp1 and a Powershot G5.

Am I doing anything wrong?
I would appreciate any help.

Best regards
Klaus

Hello,

the canon support files (non EOS) was corrupted. Please download it again and install it. It should work now.

Regards,
nabocorp

Hello,

the canon support files (non EOS) was corrupted. Please download it again and install it. It should work now

thanks very much, yes, now everything's working.

Best regards
Klaus Schulz