nabocorp softwares

Have downloaded latest shareware version and installed but get the following error when loading the application:

"the procedure entry point SetMenuInfo could not be located in the dll User32.dll"

Am unable to load the application.

In fact during the install I got a message dialogue box telling me to make sure I closed cam2pc to continue installing, even though I had not installed the programme.

I am running WindowsNT4.0 - maybe cam2pc is not compatable with this OS.

Anyone any ideas to resolve this problem - would be appreciated

Hello,

I have not tested cam2pc on NT4 because I thought that it should run without any problem. I will try to make it compatible with a patch version later on. Stay tuned!

Best regards,
nabocorp